DAPAudio P-700 User's Guide download pdf (Page 7)

Backside

5. Power cord

6. Fuse

7. 5-way Binding post output Connectors

8. Signal Ground Lift Barrier Strip

9. Bridged, Parallel, Stereo

10. Balanced Phone Jack Inputs

Installation

Palladium Vintage Installation

Remove all packing materials. Check that all foam and plastic padding has been removed.

Screw the equipment into a 19" rack. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.

Do not supply power before all components of the system are set up and connected properly.

Connection Input

The balanced phone jack inputs have a nominal impedance of 20 KΩ (10KΩ with unbalanced wiring) and

will accept the line level output of most devices. The correct input depends on 2 factors: (1) whether the

input signals are balanced or unbalanced, and (2) whether the signal source floats or has ground reference.

Figures provide examples of recommended connection techniques for each type of signal source. The

optional connector is shown.

The amplifier’s built-in 1/4“-Input-Phone-Connectors can be wired similarly for balanced or unbalanced,

floating or ground-referenced sources.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

DAPAudio P-700 User's Guide Page 7