LIVE 16 ORDERCODE D2211
8Stereo-Channel Section16) LINE L / R1/4 jack line input for L/R balanced stereo line level signals.status. When using monoline signal, use the L side
921) AUX1This is normally placed after the EQ section and before the channel fader (PRE-FADE, POST-EQ), and is therefore unaffected by the fader posit
10MASTER-Section29) Output Level IndicatorThis is a level indicator, which shows the output level of the Left &Right channel and G1 & G2.30) O
1136) POWER SwitchThe Power LED will illuminate when you push this switch.37) PHANTOM POWER SwitchThe Power LED will illuminate when you push this swi
12MIXER Output-Section43) STEREO AUX RETURNS & AUX SENDSThese can be used to connect all kinds of effects.44) G1-G2 OUTOn these outputs is connect
13Connection CablesTake care of the connector cables, always holding them by the connectors and avoiding knots and twistswhen coiling them: This gives
14MaintenanceThe DAP Audio LIVE 16 requires almost no maintenance. However, you should keep the unit clean.Disconnect the mains power supply, and then
15Block Diagram
16Product SpecificationModel: DAP Audio LIVE 16InputsMic Input electronically balancedBandwidth 10 Hz to 60 KHz ±3 dBDistortion (THD & N) 0.01% at
2004 Dap Audio.
Congratulations!You have bought a great, innovative product from DAP Audio.The DAP Audio LIVE 16 brings excitement to any venue. Whether you want simp
12234445556810121314141516DAP Audio DAP Audio LIVE 16™ Product GuideWarning..…...
2WARNINGFOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLYBEFORE YOUR INITIAL START-UP!SAFETY INSTRUCTIONSEvery person involved with the inst
3• Make sure that the available voltage is not higher than stated on the rear panel.• Make sure that the power-cord is never crimped or damaged. Che
4Description of the deviceFeaturesThe LIVE 16 is a mixer from Dap Audio.• 8 Mono Input Channels with goldplated XLR connectors and balanced Line Input
5InstallationRemove all packing materials from the LIVE 16. Check that all foam and plastic padding is removed.Connect all cables.Always disconnect fr
6Input-Channel-Section1) MICElectronically balanced XLR-connector input socket. For connecting low signalsources such as microphones or other low impe
78) AUX1This is normally placed after the EQ section and before the channel fader (PRE-FADE, POST-EQ), and is therefore unaffected by the fader positi
Comments to this Manuals