DAPAudio PS-112A User's Guide download pdf (Page 8)

Controlpanel

Fig. 2

1) Bass

Use to adjust the Bass frequencies to your preference.

2) Treble

Use to adjust the treble frequencies to your preference.

3) Overload LED

4) Volume

Use to adjust the volume level for each channel to your preference.

5) Combo Input

6) MIC/ LINE- Button

Allows you to set the input impedance/ sensitivity to either Line or Microphone level (Line =

on, microphone = off).

7) Link XLR Output

8) AC Power Switch

This is the main Power switch. Press to turn the PS-112A on.

9) Power LED

Indicates that the unit is on.

10) AC Inlet with integrated fuse holder

This connector is meant for the connection of the supplied main cord. Connect one end of the

power cord to the connector, the other end to the mains, then turn on the power switch (13) to

operate the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains.

Replace the fuse only with a fuse of same specification (F8A).

Operation

Installation

Remove all packing materials from the PS-112A. Check that all foam and plastic padding is removed.

Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.

Do not supply power before all components of the system are set up and connected properly.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

DAPAudio PS-112A User's Guide Page 8